pedal plug CablePower Up to 11 Pedals from a Single Supply The Power All 11 Lead Right Angle Daisy Chain Cable distributes power from a single adapter to up to eleven guitar pedals. Its an easy and reliable way to power an entire pedalboard without the need for multiple power supplies. Low profile right angle barrel plugs keep cables close to the pedal chassis, reducing clutter and saving valuable space on crowded pedalboards. Whether youre running a compact setup or

Power Up to 11 Pedals from a Single Supply

The Power-All® 11-Lead Right-Angle Daisy Chain Cable distributes power from a single adapter to up to eleven guitar pedals. It’s an easy and reliable way to power an entire pedalboard without the need for multiple power supplies.

Low-profile right-angle barrel plugs keep cables close to the pedal chassis, reducing clutter and saving valuable space on crowded pedalboards.

Whether you’re running a compact setup or a large effects rig, the C-11/R provides flexible power distribution with secure, dependable connections.

Specifications

Connector Configuration

• 1 × Female barrel jack (power input) [*C-M/M & C-BK Cable may be required to connect C-11/R to brick-style power supplies]
• 11 × Right-angle 2.1mm male barrel plugs (pedal outputs)

Connector Size

• 5.5 mm outer diameter
• 2.1 mm inner diameter
• 10 mm barrel length

Cable

• 26-gauge OFC cable
• Oil-resistant vinyl sheath

Spacing

• 12 in (approx. 305 mm) cable length between plugs

TIPS:

• Output polarity of C-11/R’s Male Barrel Plugs will match output polarity of power supply connected to Female Barrel Jack (i.e. if the Power Supply is tip-negative, then all C-11/R outputs will be tip-negative)
• Connect C-M/M Cable to C-11/R’s Female Barrel Jack to connect to brick-style power supplies or other sources with Female Power Output Jacks
• Connect additional Daisy-Chains to C-11/R’s last male Barrel Plug to power additional pedals*
• Connect Cable-Red to female jack of C-11/R to reverse the output polarity of all male plugs
• Connect Cable-Red to male plug on C-11/R to reverse the output polarity of that plug
• Use C-Cap to cover unused male Barrel Plugs & prevent short-circuits

NOTE:

All effect units to be powered should have the same ground configuration to-chassis. Effects with different ground configurations cannot be powered off the same PA-9 unit without using the Ground Hound ground isolator unit (sold separately). Please contact us at [email protected] for more information.

*Sum of current draws of pedals used should not exceed maximum output current of Power Supply.

**Pedals and Power Supply sold separately.